I just installed a new cFP-DIO-550 module in my compact Fieldpoint system. The unit was tested yesterday and performed perfectly. Today, upon booting up the system, I notice that the DIO-550 module won't power up. When I connect power, all the status LEDs on the module flash dimly, then go out. All the other modules are working fine. I know there's a firmware issue in the knowledgebase similar to this one, but it only applies to Rev. D and earlier, while mine is Rev. E. How can I resolve this issue?
Suggest you move the cFP-DIO-550 to a different slot on the backplane and double check any power supply connections/voltages to the module. If it still doesn't work, it's most likely a case of infant mortality and you'll need to contact NI.