cFP-AIO-610 outputs go high during reboot

[vrundquist]

I have a cFP-2100 with a cFP-AIO-610 and a cFP-TC-120.  Whenever I issue a reboot command from MAX, LabView Real Time project explorer or programatically in a .vi the outputs on the cFP-AIO-610 go high (10.2 volts).  This is a big problem while it is connected to my equipment.  I have the power up states of the four output channels set to 0 in the MAX configuration setup.

Has anyone had a problem like this?

Thanks,

Victor

[Steven_T]

Hello Victor,

This does seem like a strange issue.  Especially if you have the power-up voltage set.  I would recommend contacting us directly for a potential fix.  This issue has been noticed in some earlier versions of the cFP-AIO-610, but has been fixed.  You can request support by going to ni.com/support or by calling a customer service representative (800) 531-5066.

I hope this helps.

Steven T.