FieldPoint Family

cancel
Showing results for 
Search instead for 
Did you mean: 

FP-AO-v10 help

Hello;
 
I have two FP-A0-V10 analog output modules and first one is working fine but the other one is not recognized by the FP software. When I insert the second one the power and ready leds start to blink but when I just insert the first one the power and ready leds does not blink and its working fine. I see that there is an error with the second one. What should I do? Are these modules repairable?
0 Kudos
Message 1 of 3
(2,736 Views)
Caner,
      Please take a look at this document.
Also, Please try the module in different slots and reduce the system down to your FP controller and the TB-10 base.

Thanks,

Nathan
0 Kudos
Message 2 of 3
(2,719 Views)
If the behavior still persists, please contact National Instruments Support to RMA the module.
0 Kudos
Message 3 of 3
(2,673 Views)