01-19-2020 02:44 PM
I tried to run a robot code on my roboRio, but it said that the version of labview that is running on my pc is not the same as the target and so I imaged it. After I did it the status light started blinks twice and it will not connect on my driver station.
Solved! Go to Solution.
01-20-2020 01:57 PM
Hello NemoL,
Did you see any errors while reimaging the roboRIO? I would try the following:
I recommend you also check out the steps in: FRC Firmware Update Failing
Good luck with Infinite Recharge!