I'm going to be using a PCI 6514 DIO card to run a test machine (other
cards doing the DAQ). I'm trying to figure out the best option for
connecting to the thing to the test box. The thing is, I'm only going
to be using about 13 pins on that card and I need to pass these wires
into a control box.
I've got the 185095-02CABLE ASSY, TYPE SH100-100-FLEX, 2 m. Its very
bulky. Its 2 meters long, and has 2 cables, ~1/2" diamter, running
between the connectors. Even if I do use this, does anyone know a
mating AMP bulk head connector with solder connections in the back, to
put on a test box?
I've also got the low cost CB-100 series setup, which is nice for
bench testing, but doesn't clean up very well for a production machine..
I've looked at the 776990-01SCB-100
Noise Rejecting, Shielded I/O Connector Block, but this is a pretty big
chunk of metal to hang off of the back of the PC out into the test
area, mainly because its got pin outs for all 100 pins.
Ideally, I guess I'd like a shell that interfaces to the PCI-6514, that
I can add my own wires to. Does anyone know the specifcation to use
when hunting for mating connectors?
~~~~~~~~~~~~~~~~~~~~ Paul Johnson Renco Encoders, Inc Goleta, CA ~~~~~~~~~~~~~~~~~~~~
We provide part numbers for our 100 pin connectors, both cable and board-mount in this knowledgebase. You may need to save or print the image to be able to read the table correctly. These connectors can help you make a custom connection to PCI-6514 to meet your requirements.