From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
Sounds strange, but my task requries being compact, so someone suggests me just cut the cable and add a connector to suit, instead of using the CB-50 connector block. However, is this method possible, and can I get the wire configuration of the cable? As I have to find out the wire I should use to connect to the output pin of an accelerometer.
Can you please create an email service request at www.ni.com/support so we can
discuss this further. If you put Attn: Jesse O. In your email it will get
directed to me.
Regards,
Jesse O.
Application Engineering
National Instruments
