01-19-2021 08:27 AM
Is there a way to fix the x-axis to the bottom of the plot area without doing so manually?
After putting some curves into a Report plot and setting the y-axis scaling to "Fully Automatic", the x-axis sometimes (not always) is lined up with the 0 on the y-axis, but I want the axis to always be at the bottom of the plot area. However, if I manually adjust the scaling even a tiny amount, the axis snaps to the bottom of the plot area where I want it. I am making many plots, so correcting them all by hand is not a solution.
Solved! Go to Solution.
01-21-2021 12:29 AM
Hello cdbocksti,
If you use any grid for the axis system, the x-axis will be aligned to the bottom of the 2D axis system.
Greetings
Walter
01-21-2021 02:55 AM
Thanks!
01-22-2021 05:25 PM
Hi All,
You can also go to the Axis Position tab (the one in the middle) and specify there to have the X and/or the Y axis pinned to bottom and/or left of the graph, even without a grid. I end up doing that a lot, because I like the open axis system.
Brad Turpin
Principal Technical Support Engineer
NI