Showing results for 
Search instead for 
Did you mean: 

9411 Cabling - Impedance Matching

Go to solution

What is the recommended characteristic impedance of the cable used to connect a sensor to to the NI 9411's differential DIa/DIb channels? Would either 100 ohm or 120 ohm be appropriate?

0 Kudos
Message 1 of 2
Accepted by topic author 9Ra26M

There isn't a recommended cabling impedance because the signal frequencies that device supports are far too low for reflections to be a problem.  See here:


You could match the cable impedance to your signal source's output impedance if you really wanted to, but you'll still have a discontinuity when the signal reaches the 9411's 8.4 kOhm input impedance.  Again, this is not a problem.  Use whichever cable you want.

Message 2 of 2