01-21-2011 11:53 PM
Thanks for the warm welcome and support. Im currently doing a project with ECG monitoring system. Where I've to create a circuit using labview to interface ECG signals onto the monitor.
Once the ECG reading is sensed, these readings will be transmitted to the Receiver circuit.. The Receiver circuit will be wired to a Data-Acquisition(DAQ) hardware which is connected to the user's computer through USB port. At the same time, Labview programme running on the computer. Readings captured from the DAQ will be continuously plotted on the Labview waveform graph. Thus, the ECG waveform is obtained.
How do I go about doing it? Im new to Labview and am having difficulties in managing it doing the diagrams on Labview VI. My deadline is next week, so its a bit of a rush for me. Hope you could help, thanks!
Best regards
Anas
01-22-2011 12:05 AM
Hi,
hey u can do this ur task very easly in Biomedical Start up kit.
Best Luck.