PCAN USB for simulating CAN environment

[Surya_lol]

Hello,

I would like to Simulate a CAN environment without actual CAN node.

I would like to connect a PCAN USB which is connected to PC to other PCAN USB which is connected to Other PC i.e. I would like to establish a communication between two PCs using two PCAN Usb connecting each other.

Is it possible to connect two PCAN USB interface and simulate a CAN system?

I request to help regarding this.

[Marcus Flohr]

Hey,

i guess it is possible. But i think it is kind of complicated.. why not just using Ethernet ?

However, if you wanna do this i think you have to implement the drivers of the PCAN USB device. 

[Surya_lol]

Hi Markus,

Thanks for the replay.

I connected the PCAN USB interfaces and simulated a CAN environment.

I used PCAN USB because this is device we use to monitor CAN node in real set up.

Now simulated environment is working fine in which PC is acting like a real CAN node.

Regards

Suresh

[Marcus Flohr]

Ah..Great. So your isse is kind of fixed.. ?

[TCL]

hi surya is it possible to check the device in NI measurement & explorer

[Surya_lol]

Hi ,

NI measurement & explorer supports only NI CAN devices.

PCAN is not supported by NI.

Hence it is not possible to check this device through NI measurement and explorer.

Regards

Suresh

[TCL]

can you share some VI regarding initialising PCAN in labview & reading CAN messages

i wll be very thankful to u

[Surya_lol]

HI,

PCAN is not an NI supported Hardware.So i think its is not possible to configure it through Labview.

I didnt used Labview for my set up.I used PCAN view.This application software is supplied by PCAN user interface vendor(Peak systems).Through this you can configure the PCAN hardware,send and receive messages.

[TCL]

i had built the VI & its working  thks for reply

[Surya_lol]

oh...thats great!!