09-15-2012 06:55 PM
I have no idea where to even begin! My objective is to establish communication between LabView and a John Deere tractor Vehicle Control Unit. I want to be able to turn on and off certain inputs and outputs and perform certain functions.
Where do I begin?
Thanks.
09-17-2012 08:38 AM
There are many people at John Deere that have done this. Folks at PEC in Waterloo, Iowa, USA; Tech Center India in Pune, India; and folks in Mannheim, Germany.
I work at the PEC in Waterloo and can probably help you get started or get in touch with the right people who can help you better than I could. If you could send me a message from your John Deere account to my e-mail (link in signature below), I can help you off of the boards. If you are not with John Deere, I cannot help you as what I know is covered under a non-disclosure agreement. I hope you understand.
Good Luck,
Bob Young