07-10-2020 12:44 PM
Hello, I wrote a program to send an output from 0 to 10V dc. It worked for me when testing it but when anyone else uses it, it doesn't always function. In fact, it will refuse to send out any voltage. The voltage (0 to 10V) is needed for a device. This device will always function with a power supply unit. I have had the users reset the channels in the setup and it it still may not function. This is also a student edition of LabVIEW. Is there anything that could cause this strange behavior?
07-12-2020 08:24 AM - edited 07-12-2020 08:30 AM
My mistake! I went off on a rant about myRIO, didn't notice you clearly said "myDAQ". I don't have a myDAQ at hand, so I'll let others comment ...
Bob Schor