topic Re: change between cases in LabVIEW

change between cases

thess — Fri, 23 Oct 2009 06:22:21 GMT

i have this vi diode-transistor. it should change from diode to transistor and back with the enum on the front panel.i ve looked in the forum for other people having the same problem and did what i found but nothing worked. please take a look if you have the time and tell me what you think. thanks in advance

Re: change between cases

Christian Mergl — Fri, 23 Oct 2009 06:45:17 GMT

Hey,

Please have a look at the statemachine or producer/consumer design patterns, I think this could help you.

You will need to place the enum inside a loop. In your code it will be read once, just at the start of your VI.

Christian

Re: change between cases

jcarmody — Fri, 23 Oct 2009 10:39:02 GMT

I don't understand the question...

Re: change between cases

GerdW — Fri, 23 Oct 2009 13:18:22 GMT

Hi thess,

you used a RING and not an ENUM. They are NOT the same!

Anyway: you already wired it up. Where did you have problems exactly?

I would only remove those locals on the right side, just use wires from their terminals...

Additional note: I couldn't read a lot of your labels. What language settings are you using?

Re: change between cases

thess — Fri, 23 Oct 2009 14:47:55 GMT

i am from greece that's why. my labels are in greek. thanks for taking the time to have a look at it though. i just opened my pc again so i ll spend some time to look at it again and get back to you. thanks again.