Configure SCXI-1000DC for use with Dewesoft via 6062e

[smiffy]

How can I configure SCXI-1000DC chassis to show more than one module in Dewesoft via 6062e? I can see 16 channels but only from the first module.

The layout in SCXI-1000DC is:

SCXI-1314 into SCXI-1520

SCXI-1300 into SCXI-1100

SCXI-1304 into SCXI-1102

SCXI-1531 (8 x BNC connectors/analogue inputs)

Using NI-DAQ 7.4 to setup chassis. Have tried NI-DAQmx and traditional NI-DAQ, both will only show the first module in Dewesoft.

[MHa]

Hello,

you have used wrong forum here. Please get in touch with producer from Dewesoft - www.dewetron.com.

Best regards,
MHa

[ByungTaeBae]

Hello Sir...

I know my  question is not match with this Daylab Forum. But there is no way to find any kind of related question.!!!

I also simillar problems like you..

I'm using also SCXI-1000 strain gage signal conditionor module with PXI module.

My Dewesoft also only can recognize the first PXI Module, that means I can't use SCXI in Dewesoft.

Did you find any solution to apply SCXI-1000 into Dewesoft.??

I hope good news from you.

Thank you.

[MHa]

Hello,

you have always used wrong forum here. The situation is same - please get in touch with producer from Dewesoft - www.dewetron.com. We can only help you if you use DASYLab instead DEWEsoft.

Best regards,
MHa

[MHa]

Hello,

you have always used wrong forum here. The situation is same - please get in touch with producer from Dewesoft - www.dewetron.com. We can only help you if you use DASYLab instead DEWEsoft.

Best regards,
MHa