03-08-2012 08:43 AM
Hello,
I'm working for Airbus on the replacement of a device used to measure the noise inside the cabin of the aircrafts. The measured data are placed into a .bin file according to the IENA protocol. It is a specific protocol used in the aeronautic for the data arrangement. I wondered if there is any chance that Labview takes into account this specific protocol.
Thanks
Gabriel
03-13-2012 04:57 AM
Bonjour
Tout d'abord je vous remercie pour le post sur le forum.
J'ai fait des recherches sur le protocole LENA en vain. Pourriez vous m'en dire plus afin que je vois si LabVIEW prend en charge ce type de protocole? Est ce seulement un arrangement des données?
Cordialement
Anthony FEY
Ingénieur National Instruments
04-12-2012 05:34 AM
I'm working for Airbus on the replacement of a device used to measure the noise inside the cabin of the aircrafts. The measured data are placed into a .bin file according to the IENA protocol. It is a specific protocol used in the aeronautic for the data arrangement. I wondered if there is any chance that Labview takes into account this specific protocol.
Thanks
Gabriel
********************
Hello Gabriel,
my name is André Leroux and I am intrumentation expert at Snecma Villaroche. I have the same question about collection 100 T/C and communicate
this data to a recording system using IENA protocol.
Can we work together ? I think I am very close to a solution.
Yours,
André Leroux
Senior Instrumentation specialist
Snecma Villaroche
Ground and Fligth Test Department
Instrumentation Group
+33 1 60 59 7004
11-14-2012 10:04 AM
Bonjour M. Leroux,
We have made a POC (Proof of Concept) on IENA protocole under LabVIEW UDP broadcast for EADS division, so I invite you to connect with our local NI sales and you could have a relation link with our System engineer
Regards,
Eric PAYEN DA ROCHA | Responsable Commercial Sud-Est Senior District Sales Manager Marseille(NI France) | eric.payen@ni.com
Mobile : +33 6 83 87 95 57