NI Home
Cart Cart | Help
Hello Events Academic NI Developer Zone Support Solutions Products & Services Contact NI MyNI
You are here: 
 NI Home > NI Developer Zone > NI Discussion Forums

Wireless Sensor Networks

turn on suggestions Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Reply
Topic Options
Member ShKoush
Member
ShKoush
Posts: 11
0 Kudos

crossbow Drivers and examples

Options

‎02-06-2012 01:43 PM

- Does any one know the diffrence between Node and point?  I downloaded the drivers and tried to take a look at the VIs. There are multiple read sensor: Read sensor(MTS310)  Nnode-Npoints , Read sensor N nodes 1 points .... and I don't know which one has to be picked. My application is reading 2 MTS310 sensor borad on 2 MicaZ nodes.

 

- My other question is that, when I run the program " readhealth.vi", when I trun 2 micaz on to communicate with the gateway, I can see the data of one node gets assigned to the other senosr node. For example, in my VI, GUI, I can see NodeID: 3 but data is for NodeID 2. Can anyone explain to me why it happens? 

 

 

Thanks,

SK

Message 1 of 2 (543 Views)
 
Reply
Active Participant PackersFan
Active Participant
PackersFan
Posts: 253
0 Kudos

Re: crossbow Drivers and examples

Options

‎11-25-2012 10:24 AM

You should probably move this to the LabVIEW forum.  This forum is specifically related to NI WSN, not 3rd party WSN devices.  You'll get a quicker response over there.

Chris
Certified LabVIEW Developer
Message 2 of 2 (389 Views)
 
Reply
By using this web site, you accept the Terms of Use for this web site. Please read these Terms of Use carefully before using any part of this site. Please go here for information on ni.com's copyright infringement policy.
My Profile | Privacy | Legal | Contact NI © 2011 National Instruments Corporation. All rights reserved.    |    E-Mail this Page E-Mail this Page