Wireless Sensor Networks

[hugosantos]

Goog  morning Engineers,

How to make the connections on the outputs of the letter wsn 3202?

[PackersFan]

Connections to what?  What are you trying to control/measure?

[hugosantos]

The situation is as follows, I intend to obtain a value of output voltage of the deviceWSN 3202, through a condition imposed in labview (example attached), I intend tooperate a relay. But until now still can not get any kind of value.
Greetings.

[hugosantos]

Attached sending

[PackersFan]

Okay, that VI looks fine.

Are you not seeing the output values?

Do you read good input values?

[hugosantos]

Yes I see the input values​​.
But the doors do not get any output value. 

(Attached will the calls made.)

[PackersFan]

You need to supply DIO Power (pin 17).

[hugosantos]

I've done that. I called the Power DIO - DIO 0 and not obtained anything. Will have to give the value in the program?

[PackersFan · Accepted solution]

Sorry, I'm very confused by your response.

You should not need to set anything about the power programmatically, just wire up a power supply to DIO Power and the DIO Ground.  Then your DIO lines should be able to output values.

Also, I do think you may need to setup the line as output.  This would be done from the project.  I don't remember which element it is, but it should be in some Properties menu (probably for the specific DIO line).

[hugosantos]

Thanks for your reply, helped a lot. I'll try again, and then say what was the result.
Regards.