Switch transceiver from RX to TX during code execution

[Trincuenta]

Hey everyone,

is there any way to switch the transceiver from the same USRP RF-port from Rx to Tx (and vice-versa) during the code execution (even if this switching is controlled by the host)?

I don't know of any example project that does that.

Joao

[Wired_]

State Machines inside a case structure or timed start can be used depending one likes to control via panel or auto reset.

[atafa]

Dear Wired_

Can you give me the sequence block of using 1 USRP for Rx and Tx ?

I'm done with Rx side..from open session until close session...

But I still find difficulties to build the Tx side..

My goal is get signal data using Rx side, process it..and finally, transmit it on Tx side..with the same USRP..

Regards..

[Wired_]

Hi!

You can see this example. It's same as you want to implement.

https://decibel.ni.com/content/docs/DOC-40661