SignalExpress

[alan4]

have someone an example of how to create a vi in labview and then run it in signalexpress,

in signal express i ca run any vi form labview or only vi's that have relation with the daqmx??

have ssomone one simple example to lend me or any tutorial or something, i am new in this please  i need help.

THANKS!

[alan4]

CAN SOMEONE MEAK AN EXAMPLE OF AN SINE WAVEFORM IN LABVIEW ABLE TO READ IT FROM SIGNALEXPRESS PLEASE??

THANKS!

[DFGray]

The examples which ship with SignalExpress show you how to do this.  The examples and getting started guide both have examples.

[JesusG · Accepted solution]

Hi, alan4,

you can find all this information in the LabVIEW Signal Express Getting Started Guide, located under Help of SE menu. Once there, go directly to chapter 6: Importing LabVIEW VIs into LabVIEW SignalExpress as Steps. You can read the procedure and the kind of VIs which can be called from SE:

You can call a LabVIEW VI from LabVIEW SignalExpress to do the following:

• Control GPIB instruments

• Control National Instruments hardware that LabVIEW SignalExpressdoes not support

• Read or write data to more file formats

• Display operator instructions in a pop-up dialog box

• Define a measurement algorithm

So, answering to your questions: you are not limited to NI-DAQmx LabVIEW VIs to call them from SE, you can call from there any VI you need. The best example/tutorial is on pages 6-2 and 6-3 of this tutorial. They contain all the required information you need to know.

I hope this helps!!

Jesús.