03-26-2015 07:31 PM
Hi,
I'm new to LabView . I want to do frequency sweep test using Sound and Vibration Assistant. I added the sweep step and chose sin wave frequency as the parameters. I selected frequency from 1K hz to 10k hz with an increment of 500hz.
However, I do not know how to stay at one frequency for a while when sweeping the frequency. I hope there will be 200 cycles ( or 5 minutes) at one frequency in order to get steady result.
Could anyone tell me how to set this? Thank you!
Yue
03-27-2015 03:49 PM
Would you be able to post a screenshot of how you are configuring SignalExpresss? What hardware device are you using?
-Jayk
03-27-2015 04:40 PM
Thank you for your reply!
I am using a shaker connected to the amplifier. Attached please find the plots.
Lena
03-28-2015 08:14 PM
03-30-2015 10:18 AM
I'm sorry.
cDAQ-9174
03-31-2015 07:47 PM
What module are you using in the cDAQ 9174? It's useful to know all hardware devices that are being used.
-Jayk