09-20-2014 11:42 AM
Hi,
I am using USRP N210 with LFTX/RX boards for Wired communication (Electromagnetic Induction) and programming using LabVIEW and have downloaded the drivers. I need to command the USRP to send a sine signal of 1MHz through the wire. I have used "Simulate Sine block" but am unsure of the blocks to which this must be wired to. Please let me know the steps or the blocks/VIs which might be helpful.
Thank you.
09-22-2014 10:07 AM
Hi vishesh,
Please try to limit yourself to one board when asking a question on the forum:
Duplicates:
http://forums.ni.com/t5/Academic-Hardware-Products-ELVIS/Source-sine-current-through-USRP-using-Labv...
http://forums.ni.com/t5/LabVIEW/Source-sine-Current-through-USRP-using-LabVIEW/m-p/2999431
http://forums.ni.com/t5/USRP-Software-Radio/Source-a-Sine-Current-using-USRP-N210-using-Labview/m-p/... (answered in this post)
Thank you,