Resource Conflict on Startup -> WinHost does not find FPGA-Modules

[mikepxi]

Hi,

i'm using a PXI - Controller with two FPGA - Modules. On Startup, the BIOS shows me:

WARNING
ERROR
Resource Conflict - PCI on Motherboard
Bus:01, Device:06, Function:00
WARNING
ERROR
Resource Conflict - PCI in slot 04
Bus:01, Device:0D, Function:00
WARNING
ERROR
Resource Conflict - PCI in slot 02
Bus:01, Device:0F, Function:00
Press <F1> to resume, <DEL> to enter SETUP

After Resuming, my Windows-Host recognizes the PXI-Controller, but not the FPGA - Modules.

I've already tried to put the FPGA-Modules in different Slots. The error for the Motherboard resists also if there's only the controller in the chassis.

thx i.a. for your advices, mike

Hardware
Controller: PXI-8176
Chassis: PXI-1031
FPGAs: PXI-7813R

Software:
Labview 8.2

[Dippi]

Hi mikepxi,

I searched for a solution of your PXI - FPGA problem and found only one hint.
An other customer had the same problem, and he tried a new BIOS version.

It seems that this solved his problem, because he was very satisfied.
So please try to install the new BIOS.

Hope this helps.

Best regrads
Dippi

[mikepxi]

thx for your advice.
I've tried the 1.50 you've sent me and a 1.81 BIOS Version which i've found on your ftp:
now i have a lot of additional configuration options, but the errors are the same.

our local PXI-Support thinks that the Controller is wrecked, we've got a new one 🙂

regards, mike