11-03-2013 03:57 AM
HI , evryone
here is my question i have to controle my IHM versitand using labview (load models simulation,mapping and so one )
can you help me to do this
regards OULD OUALI Nacim
11-04-2013 02:35 AM
Hello,
Could you be more precise ? We don't actually know what you are willing to do... A good start point is taking a look at the examples shipped with LabVIEW when VeriStand is installed. They should be here :
- C:\Program Files (x86)\National Instruments\LabVIEW 20xx\examples\NI Veristand\API\
Regards,
Eric M. - Senior Software Engineer
Certified LabVIEW Architect - Certified LabVIEW Embedded Systems Developer - Certified LabWindows™/CVI Developer
Neosoft Technologies inc.
12-03-2013 08:45 AM
hi,
what I want to do is to import my two models one on AMESim and Simulink and after the i build my interface then retrieve all labview in order to have a dynamic interface, but I want it to be therefore standard any time I can change the models in VeriStand to test other equipment without changing the architecture of my labview interface
please i need help