Does anybody know how to create a table of parameters for a user to interact with (in edit time) for a custom step type? When you create a standard Action step, for example, with a LabVIEW VI, it gives you this nice table of parameters on the Module tab that are the ins and outs of your VI. You can enter values or variable names here.
However, when you create a custom step type with that same VI as a post-step, the table of parameters is embedded in the step and the user can no longer interact with the inputs and outputs of the step through that nice table interface. Perhaps this is good (in that you could have multiple VIs with lots of parameters, so how would the step know what to display and what not to display). But it would be nice to still be able to create a set of parameters for your custom step that the user could interact with. Presumably, in the creation of the custom step, you'd have to define how these parameters map to the ins and outs of the VIs that you setup as post-steps (or pre-steps, etc.).
Thanks!
E-Mail this Page