 |
|
||||||||||||
I'm taking a bunch of steps and trying to put a "If" flow control step around them.
Kinda like this:
But what I end up with is just a If/End statement in the middle of the steps that I selected (well, after the first step in the selection)
What I would have liked to see is this:
Whare the If/End wraps the steps that I selected.
I don't quite know how best to handle the situation where the steps you have selected are not sequential (there's an unselected step in the middle), but that could probably just behave how it is now.
Do you have a feature idea for how to improve NI TestStand? Submit and vote on ideas now!- Browse by label or search in the TestStand Idea Exchange to see if your idea has previously been submitted. If your idea exists sure to vote for the idea by giving it kudos to indicate your approval!
- If your idea has not been submitted click
Post New Idea to submit a product idea. Be sure to submit a separate post for each idea. Note: the TestStand Idea Exchange is not the appropriate forum to submit technical support questions. - Watch as the community gives your idea kudos and adds their input.
- As NI R&D considers the idea, they will change the idea status.
- Give kudos to other ideas that you would like to see implemented!
The TestStand R&D team is committed to reviewing every idea submitted via the TestStand Idea Exchange. However, we cannot guarantee the implementation of any TestStand Idea Exchange submission until further documented.
|
||
|
||
My Profile | Privacy |
Legal |
Contact NI
© 2011 National Instruments Corporation. All rights reserved. |  E-Mail this Page
|
||
|
||