NI Home
Cart Cart | Help
Hello Events Academic NI Developer Zone Support Solutions Products & Services Contact NI MyNI
You are here: 
 NI Home > NI Developer Zone > NI Discussion Forums

NI Community Beta Discussions

turn on suggestions Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Reply
Topic Options
Member franco.atzeni@…
Member
franco.atzeni@terna.it
Posts: 3

Clean Up Diagram

Options

‎09-12-2008 05:22 AM

Hi everyone,

 

I'm trying the new tool in LV8.6 to clean up the diagram.

 

It works ok but i'd like to have the possibility to lock a part of  diagram so labview can clean up only the unlocked part.
Message 1 of 2 (1,941 Views)
 
Reply
Member Little Helper
Member
Little Helper
Posts: 139
0 Kudos

Re: Clean Up Diagram, LV 8.6

Options

‎10-03-2008 02:24 AM

Hi Franco

 

I would like the very same thing too :-)

 

It is a pretty great tool and long needed, but as you say, it would be even more great if you could lock some of the diagram or mark the part of the diagram that you would like to clean up.

 

Does anyone know if this is possible or will be soon?

 

Best regards

Simon

LabVIEW 8.6 / 2009 / 2010
Vision Development Module 8.6 / 2009 / 2010
VBAI 3.6 / 2010
Message 2 of 2 (1,913 Views)
 
Reply
By using this web site, you accept the Terms of Use for this web site. Please read these Terms of Use carefully before using any part of this site. Please go here for information on ni.com's copyright infringement policy.
My Profile | Privacy | Legal | Contact NI © 2011 National Instruments Corporation. All rights reserved.    |    E-Mail this Page E-Mail this Page