simulate error ：opa141 op amp DC operating point cann't converge

[lee_login]

HI there

I'm using the Multisim 14.0.0. There's a 8-pin opa141 available in the library. I wanted to use it for a amplifier, but a simulation error has occured. The report said that 'DC operating point calculation did not converge'.

i had tried using opa 241,opa 4141,they all have this problem，Pspice model error？

------ Checking SPICE netlist for Design1 - 2017年5月10日, 16:09:05 ------
======= SPICE Netlist check completed, 0 error(s), 0 warning(s) =======
DC operating point calculation did not converge
op simulation canceled

[vlad3156]

Hi..
.. as the OPA141 normally works ...
... most likely OPA141 is unstable at low gain factors ...

[lee_login]

in fact,i want to make a high pass filter .but i cannot simulate the bandwidth.

 in high gain , DC operating point calculation did not converge neither.

[vlad3156]

..draiwing schematic high pass filter...

[lee_login]

thankyou for help！

[lee_login]

thankyou for help！