From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
This is odd. I i would change say, a resistor to another footprint, then I have first add that footprint to multisim ? The earlyer versions dont behave like this. Sometime i feel the newer versions not always better. For example, now if i have a smd component on the top side of the board, i could wire it with the bottom copper was selected. The wire is snap to the smd pad, like the smd was on the bottom side...
You have chosen non-standard footprint - R08055. Standard - R0805. At a rate of 08055 resistors are issued seldom, therefore in Multisim such packarge is absent.