The A/D converter does not work multisim 10.0.1

[stevo50]

Is there a known problem with A/D converter in Multisim 10.0.1? I can not get either the 8 bit or the 16 bit to work.

[_user32]

Stevo50,

Yes I believe there was an issue with the basic A/D models in Multisim v10.0.   It has since been resolved.

Please try this 8bit ADC to verify.

Regards,

Pat Noonan

National Instruments

[stevo50]

I did download 10.1.1 The evaluation copy it does work in 10.1.1 but I can not get it to work in 10.0.1. When I open your file  it always goes to 10.1.1. It gives a error in 10.0.1 something about bad real value something like like that.

Thanks

Steve

[NYCtech]

hello community, im trying to simulate a schematic to get an 8 bit binary digital output from an  A/D converter in multism but im not sure about the connections. i keep getting an error message in multism .can some one please look at it!!!

[Tien_P]

You have to connect a clock to the SOC pin, this is used to trigger when the ADC, have a look at the modified file.