From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards Multisim and Ultiboard Topic

Multisim and Ultiboard

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Problem when using the Agilent Function Generator and the AD633 multiplier circuit.

Problem when using the Agilent Function Generator and the AD633 multiplier circuit.

‎04-23-2017 06:54 PM - edited ‎04-23-2017 06:56 PM

Hi,

 

I have a problem when using the Agilent Function Generator and the AD633 multiplier Circuit in that I get the following simulation error: "A simulation error has occurred. Would you like to run the Convergence Assistant to attempt to resolve this problem automatically?". This error is absent when I use the standard function generator or any of the "Signal Voltage Sources" like the AC_VOLTAGE. I am stuck Smiley Sad.

 

I am using Multisim 14.1 Student edition. The Circuit is attached.

 

Best regards,

Lars

0 Kudos
Message 1 of 1
(2,291 Views)
Reply