turn on suggestions

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

- NI Discussion Forums
- :
- Most Active Software Boards
- :
- Multisim and Ultiboard
- :
- How to use transient analysis to measure phase shift in series/parallel AC circuit?

Topic Options

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report to a Moderator

01-29-2011 04:23 PM

I can't seem to get my calculations to match transient analysis measurements. It is a simple series/parallel circuit and we are to solve for current and phase shift and then run transient analysis to compare. My phase shift calculations are not even close. I am not sure what parameters or variables to add? Any suggestions?

I will attach the circuit I am working on. Thanks.

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report to a Moderator

02-07-2011 12:22 PM

Hi Doug,

I think you made an error with your calculation, my calculation matches with Multisim.

Tien P.

National Instruments

National Instruments