From 04:00 PM CDT – 08:00 PM CDT (09:00 PM UTC – 01:00 AM UTC) Tuesday, April 16, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
I am trying to display an electric signal on personal PC that converted from a photdiode through third party conditioning signal board, can I interface this signla with basic DAQ PCI-6251. the third party board already have shielded cable 68 pin.
Hello Aneece,
Have you found the answer to your question yet?
If not then can you give some specific details on the signal coming out of the third party board please?
Thanks,
Alistair
As long as the voltage to the DAQ card is within -10V to +10V, you are fine. We use op-amps to perform signal conditioning before sending the signals to the DAQ cards.
There are only two ways to tell somebody thanks: Kudos and Marked Solutions Unofficial Forum Rules and Guidelines "Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
Thanks crossrulzfor the reply, the problem I couldn't manage to know the model of the signal conditioning board that already connected to the photodiode.
