NI Home
Cart Cart | Help
Hello Events Academic NI Developer Zone Support Solutions Products & Services Contact NI MyNI
You are here: 
 NI Home > NI Developer Zone > NI Discussion Forums

Motion Control and Motor Drives

turn on suggestions Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Reply
Topic Options
Member Wee-Bey
Member
Wee-Bey
Posts: 173
0 Kudos

Re: stepper motor control programs

Options

‎06-06-2012 06:19 PM

Hi there.

 

Sorry about that, but again, this is more likely a serial issue, and also unrelated to the original topic, which means you want to create a new thread to continue this discussion. I recommend that if your problem is to ask about how to generate a pulse via a serial command, you post that in the Instrument Control section of our boards, since you're not dealing with our Motion Control VIs and hardware, but rather with other hardware.

 

http://forums.ni.com/t5/Instrument-Control-GPIB-Serial/bd-p/140

 

This board would be your best bet.

Ravi A.
National Instruments | Applications Engineer
Message 11 of 11 (76 Views)
 
Reply
By using this web site, you accept the Terms of Use for this web site. Please read these Terms of Use carefully before using any part of this site. Please go here for information on ni.com's copyright infringement policy.
My Profile | Privacy | Legal | Contact NI © 2011 National Instruments Corporation. All rights reserved.    |    E-Mail this Page E-Mail this Page