03-06-2014 04:26 AM
I am beginner in LabVIEW.I have to control an Nd-Yag laser source.
As my work piece is moving at a particular velocity and I have to make the laser source to start emitting laser at the same time the workpiece starts moving.
I have got a motion controller to move the work piece and the Nd-Yag laser can be externally triggered.
Thanks in Advance:manhappy:
03-06-2014 09:29 AM
What is the make/model of the motion controller?
What type of signal is needed to trigger the laser?
Does the motion controller have any outputs that can be activated when motion occurs?
-AK2DM