06-07-2012 02:09 PM
Hi this is probably a naive question, but what do the red dots where wires meet subvi's mean? They don't show up as errors, but I'm not sure what is wrong with the wiring.
Thanks,
Arthur J.
06-08-2012 02:58 AM
See the Coercion Dots paragraph in this document.
06-08-2012 03:14 AM
In this case, coercion dots appear in your diagram because NI uses different type definitions for Board ID and Bd ID Out in their motion library. Therefore LabVIEW must coerce one type to the other.
06-08-2012 01:14 PM
Is there a better way to connect or convert the Board ID to the Bd ID Out so that they are the same type definitions? Or should I not be concerned with it
Thanks.
06-11-2012 03:52 AM
Avoid coercion dots in your own VIs and live with those in NI's motion library.
I don't know why NI uses different type definitions but they might have a good reason. Please call them and let us know their answer.