From 04:00 PM CDT – 08:00 PM CDT (09:00 PM UTC – 01:00 AM UTC) Tuesday, April 16, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Hardware Boards Motion Control and Motor Drives Topic

Motion Control and Motor Drives

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Ethernet Stepper motor- ISM-7411

Ethernet Stepper motor- ISM-7411

‎04-05-2015 06:53 PM

Some questions regarding the Ethernet Stepper motor- ISM-7411:

 

I would like to make a wheel to turn to 24 fixed positions.

1.How many  'Steps/Rev​' do I need to set up? 
​And where can I set up the 'Steps/Rev​' from the vi?

2. How do I configure the axis? Can I open 'Axis Configuration Dialog Box' with the ISM-7411?
3. Can I make the SoftMotion read the 'Configurator files (.st files) ' from the Stepper Configuration utility?​

 

Many thanks!

0 Kudos
Message 1 of 1
(4,228 Views)
Reply