Do I have to load torque, velocity, accel/decel, following error every time?

[NTT]

Hi,

This is my first project with NI-motion. We use NI 73xx library. I would like to know in every move, do I have to load torque, velocity, accel/decel again and again if I don't change these configuration at all?

Regards,

Thang Nguyen

[Poolean · Accepted solution]

That depends on what exactly you're trying to do, but, no, you don't have to load those parameters every time you perform a move.

There are a lot of examples to work off of that ship with NI-Motion in LabVIEW. I recommend taking a look at Sequence of One-Axis Moves, which you can find by going to Help>>Find Examples>>Hardware Input and Output>>Motion Control>>NI 73xx>>Straight Line Move.

-Mike

[NTT]

Mike,

Thank you very much!

[Poolean]

Happy to help! 🙂