LabVIEW

[Danish666]

greetings fellow programmers,
I am working on DANI robot, and created a MAP of a room, by controlling the robot's movements using Labview. I have used maxsonar EZ1 sensor. Now if I have to move it from a point A to point B in the map, how would I do so?
NOTE:Assuming there are moving obstacles (or slight change in the environment), I will use the same sensor for obstacle avaidance as well.

Any information will be appreciated.
Regards,
Danish

[smercurio_fc]

Please do not create multiple posts. You are already being helped in your original thread: http://forums.ni.com/t5/LabVIEW/Maapping-using-Maxsonar/td-p/1997827. Keep all discussion in ONE place.

[Hornless.Rhino]

---

smercurio_fc wrote:

Please do not create multiple posts. You are already being helped in your original thread: http://forums.ni.com/t5/LabVIEW/Maapping-using-Maxsonar/td-p/1997827. Keep all discussion in ONE place.

---

Link doesn't work, (you have a . at the end) http://forums.ni.com/t5/LabVIEW/Maapping-using-Maxsonar/td-p/1997827 does though

[smercurio_fc]

---

Hornless.Rhino wrote:

---

smercurio_fc wrote:

Please do not create multiple posts. You are already being helped in your original thread: http://forums.ni.com/t5/LabVIEW/Maapping-using-Maxsonar/td-p/1997827. Keep all discussion in ONE place.

---

Link doesn't work, (you have a . at the end) http://forums.ni.com/t5/LabVIEW/Maapping-using-Maxsonar/td-p/1997827 does though

---

Thanks. I hate this forum software.

[Danish666]

oh am sorry, the topic was different, so i though of addressing it seperately. But thank you for being kind enough to inform.

Cheers