LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

urgent - path planning

greetings fellow programmers,
I am working on DANI robot, and created a MAP of a room, by controlling the robot's movements using Labview. I have used maxsonar EZ1 sensor. Now if I have to move it from a point A to point B in the map, how would I do so?
NOTE:Assuming there are moving obstacles (or slight change in the environment), I will use the same sensor for obstacle avaidance as well.

Any information will be appreciated.
Regards,
Danish

0 Kudos
Message 1 of 5
(2,269 Views)

Please do not create multiple posts. You are already being helped in your original thread: http://forums.ni.com/t5/LabVIEW/Maapping-using-Maxsonar/td-p/1997827. Keep all discussion in ONE place.

0 Kudos
Message 2 of 5
(2,248 Views)

@smercurio_fc wrote:

Please do not create multiple posts. You are already being helped in your original thread: http://forums.ni.com/t5/LabVIEW/Maapping-using-Maxsonar/td-p/1997827. Keep all discussion in ONE place.


Link doesn't work, (you have a . at the end) http://forums.ni.com/t5/LabVIEW/Maapping-using-Maxsonar/td-p/1997827 does though

 

0 Kudos
Message 3 of 5
(2,216 Views)

@Hornless.Rhino wrote:

@smercurio_fc wrote:

Please do not create multiple posts. You are already being helped in your original thread: http://forums.ni.com/t5/LabVIEW/Maapping-using-Maxsonar/td-p/1997827. Keep all discussion in ONE place.


Link doesn't work, (you have a . at the end) http://forums.ni.com/t5/LabVIEW/Maapping-using-Maxsonar/td-p/1997827 does though

 


Thanks. I hate this forum software.

0 Kudos
Message 4 of 5
(2,207 Views)

oh am sorry, the topic was different, so i though of addressing it seperately. But thank you for being kind enough to inform.

Cheers

0 Kudos
Message 5 of 5
(2,199 Views)