08-29-2016 05:54 PM
Hi
i've problem with send command to linear ccd.(tcd1304ap toshiba). MAX can detect the ccd but i don't know how send these commands to ccd.
Solved! Go to Solution.
08-29-2016 07:48 PM
How is this linear CCD connected to your PC? Serial port? Digital input/output signals in a DAQ card?
08-30-2016 12:35 AM
the ccd connected to the pc by serial port.
08-30-2016 01:03 AM - edited 08-30-2016 01:23 AM
did you test your ccd comment by other softwares like hyper terminal , versaterm
,putty or x-ctu ?
it is better to check your comments working correctly before jump in labview programming
08-30-2016 07:58 AM
Then you can use VISA to read and write commands to the serial port. There are examples in LabVIEW. But you are better off searching the forums for messages about serial port communication.
09-07-2016 03:18 PM
thank you for your help,i finally find out what was my problem