LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

sbRIO-9631 and communicating using RS-232

Solved!
Go to solution
Solution
Accepted by topic author sergiovelderrain

Its been a long time since this thread was solved, but, i am succesfuly sending and receiving data from a singleboard rio through an XBEE PRO 900 HP. Do not try to use the RS232 port on the SBRIO, i have a sbRIO 9626, the logical levels ar non compatible. 

 

Instead, try making a DO0 TX and DO1 RX. I found some example code of how to do it HERE: http://www.ni.com/example/27164/en/

 

Remember, this code is probably not adapted to the sbRIO you are using, so please spend some time doing setup and configuring the code for yor sbRIO. 

 

From the PC Side, use VISA to receive from your XBEE, and from the RT side, use the VIs attached on the link i provided, there are some subVIs tha read and write and another one that starts the FPGA. 

 


Just another LabVIEW guy
CLA I CTA I LabVIEW Champion
0 Kudos
Message 11 of 11
(785 Views)