LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

reading acceleration channel properties programatically

I am creating a virtual channel that is reading a TEDS compatible accelerometer. Prior to creating the channel I execute "DAQmx Configure TEDS" on the physical channel in order to read the TEDS information. What I can't figure out is how to find and read several of the accelerometer channel properties so I can verify the TEDS information is correct. Specifically, I cannot find properties for sensitivity, or sensitivity units. I looked in "DAQmx Channel" and "DAQmx Physical Channel" porperiy nodes but could not find sensitivity. Thanks for your help.

0 Kudos
Message 1 of 2
(2,033 Views)

Hi,

 

I used to have the same problem. I spend a lot of time trying to find a property node or a VI in order to retrieve the information previously defined in the document, but unfortunately I wasn’t able to find one.

 

 

 

0 Kudos
Message 2 of 2
(1,972 Views)