04-02-2012 06:57 PM
Hello,
I am writing to know can you please help me. I am trying to writing a PID control programme for a water level control project I am doing but when I use labview and select a daq assisitant it does not show terminals onit therefore I cannot wire it up. Can you please help to rectify this.
Solved! Go to Solution.
04-02-2012 11:24 PM
04-03-2012 01:46 AM
@moonlightingelec wrote:
Hello,
I am writing to know can you please help me. I am trying to writing a PID control programme for a water level control project I am doing but when I use labview and select a daq assisitant it does not show terminals onit therefore I cannot wire it up. Can you please help to rectify this.
Am not sure why you are searching the PID terminals in DAQ assistant. Are you using any LAbVIEW PID module?
04-03-2012 12:52 PM
thank you