LabVIEW

[ni_labview1]

Hi, I am new to labview. I am doing a project on motor control. Here I have to find the following parameters of motor using Labview 7.1 version along with Labjack (U3-HV) : 1) Torque 2) Voltage 3) Current 4) Speed I don’t know how to write a code for these parameters in labview and I didn’t find any blocks like IC’s, chips, motors in control and function palette. Plz guide me for the same and post all your suggestions here. Thank you.

[danil33]

Hi labview, The IC’s, chips, motors etc: are not available in function or control palletes. For getting started with labjack,please see here http://www.labjack.com/forums/index.php?showtopic=84 http://www.labjack.com/lju12datarates.php Hope this helps.

[LabJackSupport · Accepted solution]

That is a good link to get started using the U12 with LabVIEW.  For the U3, the following are a couple good links:

http://labjack.com/support/u3

http://labjack.com/support/ud/examples/labview

See the following topic on the LabJack forums:

http://forums.labjack.com/index.php?showtopic=5894