[English]
Hy!
I read out a controller of a BergerLahr axles via RS232 (with an "RS232 to RS485" adapter) and I
use the "Modbus" protocol to do this task.
Everything works fine, but the readout rate is too slow... I am only able to achieve a rate
of approx. 10-15Hz to get the data.
Is there a possibility to boost the readout value ... (the more the better)?
- in the attachment there is the screenshot of the VI (auslese01.JPG)
- the VI itself (auslese.vi)
- and the modbusprotocol für LabView (you need it to open the VI)
(http://sine.ni.com/devzone/cda/epd/p/id/4756)
Thank you for your help & time
Greetings from Austria
Harry
--------------------------------------------
[German]
Hallo Ihr!
Ich lese über die RS232 Schnittstelle - über einen "RS232 to RS485" Adapter - einen Controller
einer BergerLahr Linearachse über das Modbus Protokoll aus.
Das ganze funktioniert eigentlich sehr gut, jedoch geschieht das Auslesen mit nur 10-15Hz...
daher bekomm ich viel zu wenig Messwerte herein.
Gibt es eine Möglichkeit die Datenerfassung zu beschleunigen?
Hab im Forum schon ähnliche Fragen gefunden, jedoch bringen die mich leider nicht weiter.
Man kann da an den Schleifen selbst, etc. Verbesserungen vornehmen...
- Anbei ist ein Screenshot des VIs (auslese01.JPG)
- Das VI selbst (auslese.vi)
- Und das Modbusprotokoll für LabView ist hier zu finden -> benötigt man zum Öffnen des
VIs(http://sine.ni.com/devzone/cda/epd/p/id/4756)
Vielen Dank für Eure Hilfe & Zeit
LG
Harry