crash labview 2014

[ahmadtarmimikassim]

Good Day 

I got an error when running VI( picoscope 5000EaxampleBlock vi)  by using LabVIEW2014( LabVIEW crash ) This also been done by using a PIcoscope 5000 series meter

Exception: Access violation (0xC0000005) at EIP=0x0000000100000000

version: 14.0 (64-bit)

attached also Lv log and SubVI.

Can anybody advice on this matter..

Best Regard

AhmadTarmimi

Universiti Teknologi Malaysia

[BowenM · Accepted solution]

Without seeing the your scope drivers, this is just speculation...

Any time I have seen a crash like that from drivers it has been a call to a DLL that caused the problem. It may be that you are running 64 bit LV trying to call a 32 bit driver DLL.

[ahmadtarmimikassim]

Hi Bowen

Thank for the reply

the DLL file already use a 64 bit( download from picoscope website) but the VI i think in 32 bit version... 

is there any method that chage VI from 32 bit version to 64 bit...

Best regards

Tarmimi 

[Yamaeda]

---

is there any method that chage VI from 32 bit version to 64 bit...

---

You install LV2014 x64.

/Y

[billko]

---

@Yamaeda wrote:

---

is there any method that chage VI from 32 bit version to 64 bit...

---

You install LV2014 x64.

/Y

---

Yes, then if you need to have a 32-bit version, have a dev statsion with LV 32-bit and the 32-bit dll.  The VIs are just the source code and will open up just fine in either LV version.

The only issue is that LV 64-bit might not have the tool kits that you need.