From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
11-29-2012 02:39 AM
hello 🙂
i have to comunicate with a oscilloscpe via usb port...well i have no idea in what way i could do it 🙂
someone can tell me which blocks i have to use to comunicate?
via rs232 i used visa read and write blocks....via usb?
thanks
11-29-2012 05:14 AM
It will still be a visa resource. Look for labview drivers for your specific scope here http://www.ni.com/downloads/instrument-drivers/ or the scope makers' website.
11-29-2012 05:23 AM
i use labview7 😞
as you can see it's not present...and now? 😞
PS: in what way can i use driver? :=) i install them...and then? 🙂
11-29-2012 05:29 AM
Unfortunately, I can't go back that far but you can post a request to save the 8.2 driver to version 7.0 here: http://forums.ni.com/t5/Version-Conversion/bd-p/VersionConversion
11-29-2012 06:43 AM
after installed my drivers (i hope to find them) what i have to do?
does someone have an example in labview 7.1 about comunication via usb? in what i must configure my port, etc...
thanks again
11-29-2012 07:04 AM
USB support was introduced in visa 3.0. I am not sure which version you are using and the how labview 7.1 will work with it!
Here is a tutorial if thats of any help: http://www.ni.com/white-paper/4478/en
11-29-2012 07:05 AM
visa 5.x 🙂
11-29-2012 09:40 AM
if i try to comunicate via ethernet, are drivers required?
11-29-2012 09:53 AM
@gigi85 wrote:
hello 🙂
i have to comunicate with a oscilloscpe via usb port...well i have no idea in what way i could do it 🙂
someone can tell me which blocks i have to use to comunicate?
via rs232 i used visa read and write blocks....via usb?
thanks
The oscilliope manual should be very helpful with this. Try reading it.
11-29-2012 11:51 AM
it tell nothing... 😞 just 2 things...
i download programmer manual (for remote control) and it's 99% full of comands only