10-24-2014 11:07 PM
currently i am working with labview, arduino and gsm interfacing project.i have all the software required for the project.But i am new to arduino gsm and labview programing,can any one please help me where to start the programming.
10-25-2014 01:22 PM
10-28-2014 06:02 AM
can you please tell me how to intialise gsm module in labview program?
10-28-2014 11:41 AM
@chandrima wrote:
can you please tell me how to intialise gsm module in labview program?
A GSM module i hardware. LabVIEW is software. Can you explain how this interaction is facilitated?
The easiest solution is LIFA. It is open source and you can add code to perform the steps needed, then ping it from a Windows PC by sending data to a serial port, which goes to the Arduino.
Unofficial Forum Rules and Guidelines
Get going with G! - LabVIEW Wiki.
16 Part Blog on Automotive CAN bus. - Hooovahh - LabVIEW Overlord
10-29-2014 03:27 AM
my doubt is how to send AT commands(for sending an SMS) to the gsm in the labview programming
10-29-2014 03:27 AM
my doubt is how to send AT commands(for sending an SMS) to the gsm in the labview programming
10-29-2014 03:34 AM
Could you post a screeshot of where in the application you have problems?
What is the specification of the GSM module?
10-29-2014 07:24 AM
it's sim900a