05-04-2014 11:50 PM
Hi guys Im New to labView
Attached is my VI,
My start button appears to be working but when i press start there is no changes to my waveform.
I am using a USB-6009
Thanks a bunch!
Prash
Solved! Go to Solution.
05-04-2014 11:51 PM
Sorry here is the VI
05-05-2014 12:54 AM
Hi, prash4,
I think you should change "mechanical action" of the Start button to non-latch mode.
05-05-2014 01:05 AM
Thank you... now another problem, waveform isnt changing as i change the voltage?
05-05-2014 01:10 AM
Hi, prash4
Where do you change the voltage? I orignally thought you just do the data acquisition.
A little confused with "the voltage changed by you".
05-05-2014 01:16 AM
Measuring the voltage through the analog inputs, changing via the power supply
05-05-2014 02:13 AM
Hi, prash4,
Do you mean you changed the signal source and didn't get the correct data?
Are the data you acquired floating arournd 0 like noise?
Do you try the NI-MAX to see if the installed hardware and the specified channel are correct and the acquisition by the "Test Panel" is O.K.?
If the NI-MAX is O.K., then debug the LabVIEW code.
05-05-2014 10:36 PM
I figured it out
Thanks