From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
LabVIEW
VI to run a motor
What kind of problems are you having? What does the motor need to run (DC voltage, pulses, gasoline, etc.)
What kind of motor is it (stepper, electric, stirling, Otto, Wankel, ...).
If it is really continuously, just plug it into a wall socket. No code needed.
I suspect that there is probably more to it....
You still need to provide more information.
Where does the EEG signal comes from.
How do you measure it?
How do you communicate with the car?
Typically, EEG is not a simple signal, but a large collection of concurrent signals. Please clarify what you actually measure.
A car much more than a motor.
Should the car drive continuously, even if the signal is not continuously?
When should the car start and when should it stop?
Should the speed and direction of the car depend on some parameters in the EEG signal?
How about steering?
AJAYKUMAR wrote:so i need an interface which can make EEG signal to run the motor of car.
It sounds like you already have interface code between EEG and LabVIEW and between LabVIEW and the car. These are not trivial and combining the two is not much added complexity. If you don't have these yet, you should do them first. Where do you have problems? Can you show us some code?
